I went to college for Electrical Engineering and worked as a research associate in the Mechanical Engineering department ( Cameron Applied Research Center at UNCC ) This was were I learned precision machine design, how to machine and fabricate in metal and started learning how to weld. While working for Brown and Sharpe as an R&D engineer, I switched from the Engineering sector to the IT sector. At the time it was primarily financially motivated... I'd switch back in a heartbeat since the IT sector is not as lucrative as in was before "out sourcing".

When I bought this house it was with the intention to setup my own machine shop. This shop is 30x30 feet, two stories, and is bigger then the actual house. I use it primarily for fabrication, repair and prototyping of projects. I prefer to have my projects funded by customers... but I do a far bit of pro-bono work if time allows and it stays fun.

My ultimate job would be to spend all my time designing, fabricating and testing for customers.

Please contact me via e-mail if you have any projects, questions or racing budgets.

Please contact our Webmaster with questions or comments.
Copyright 1998 ACS. All rights reserved.